Preventive Maintenance Agreements offer you the peace of mind that your generator is properly maintained and ready for you in your time of need. Indiana Power provides the most comprehensive Preventative Maintenance Service Agreement available. Our service plan meets the requirements and recommendations of all major generator manufacturers and industry leaders. Inspections performed include (where applicable) the general appearance, the lube oil system, the engine air filter system, the engine fuel system, the engine starting system, the engine ignition system, the engine exhaust system, the main alternator and electrical system, the cooling system, the transfer equipment and general condition with specific checks during operation to ensure peak performance.
Service inspections for generator system (where applicable):
- Inspect for visual damage and/or unusual wear and tear
- Inspect all visible plumbing and electrical connections
- Clean debris from generator and wipe down enclosure
- All switches/breakers in normal operating position
- Check engine oil level
- Change engine oil and filters
- Inspect engine seals for leaks
- Tighten hose clamps as necessary
- Inspect engine air filter
- Inspect air cleaner seal
- Inspect air cleaner elements
- Inspect crankcase vent/breather
- Inspect fuel system for leaks
- Tighten hose clamps as necessary
- Inspect flexible fuel lines
- Inspect fuel pressure as needed
- Load test battery
- Clean battery terminals/posts, tighten cables as needed
- Replenish battery fluid levels
- Inspect battery charger
- Inspect battery heater
- Inspect spark plugs
- Inspect spark plug wires and distributor cap
- Inspect points and condenser
- Inspect flexible exhaust coupling
- Inspect critical silencer
- Drain water in exhaust moisture traps
Main Alternator & Electrical
- Check voltage output, rotor, stator, regulator
- Inspect brushes and slip rings if visible
- Inspect insulation on generator leads
- Tighten connections as needed
- Inspect all belts and adjust as needed
- Inspect all hoses and hose clamps, tighten as needed
- Inspect radiator core for blockage or damage
- Inspect radiator cap and seal
- Check coolant level
- Test antifreeze for proper DCA level
- Inspect block heater
- Lube fan pulley as needed
- Inspect fan louvers for proper operation
- Ensure connections are tight
- Ensure relays are tight
- Check main contacts
- Test transfer (where permitted)
- Check for oil, coolant and exhaust leaks
- Inspect battery charging system
- Inspect turbocharger
- Inspect engine governor
- Check oil engine gauges and LEDs
- Check for abnormal vibration and/or noise
- Adjust voltage and frequency as needed
- Test all engine safety shutdowns